25 Amp Enclosed Power Relay with a 12 Volt Coil
Unit is the standard Power Relay used on Easy-Fire, eQuad-Pro, Doll, Jupiter, eFL Series, and X2300 & XB2300 Control Panels, it is also used as the Control Relay for X2800-D & XB2800-D, X3200-D & XB3200-D, T2300-D & TB2300-D, and T3400-D & TB3400-D Series DaVinci Kilns and Easy-Load kilns.
This contractor is used interchangeably as a power contactor on both 240-volt and 208-volt kilns.
25 Amp Enclosed Power Relay with a 240 Volt Coil - used on some older manual kilns that require power relays and as a control relay from some 480 volt kilns
See this page for the 12 Volt 25 Amp relay we use for most kilns.
MOV Surge Suppressor for 250 Volt / 50 Amp Enclosed Power Contactors - Unit is 5mm in Diameter, absorbs the discharge energy from the inductive coil of a contactor, and can be used on All 240 Volt or 208 Volt Contactors
The L-G-MOV1/00 MOV has a mark on it of PZ390 (you have to use a magnifying glass to see this).
Attach the MOV Suppressor to the Power Contactor by using two 16-14 AWG Insulated Female Slip on Wire Terminals for 1/4" Spades, one on each end of the MOV.
2 Pole Power Relay - Unit is rated for 30 Amps (resistive load below 300 Volts) with a 208 Volt Coil and is used in Older Manual Kilns and Renaissance Kilns at 208 Volts and any Phase Power
2 Pole Power Relay - Unit is rated for 30 Amps (resistive load under 300 volts) with a 240 Volt Coil and is used in Older Manual Kilns and Renaissance Kilns at 240 Volts and any Phase Power
3 Pole Power Relay - Unit is rated for 50 Amps with a 120 Volt Coil - Unit is the standard Power Relay on All X2800-D & XB2800-D, X3200-D & XB3200-D, T2300-D & TB2300-D, and T3400-D & TB3400-D Series DaVinci Kilns and Easy-Load kilns that are rated for 480 volts. (Note: the 480 volt input current is reduced to 120 volts for the control circuit that controls the coils of these contactors)
3 Pole Power Relay - Unit is rated for 50 Amps with a 240/208 Volt Coil - Unit is the standard Power Relay on All X2800-D & XB2800-D, X3200-D & XB3200-D, T2300-D & TB2300-D, and T3400-D & TB3400-D Series DaVinci Kilns and Hercules and Easy-Load kilns. These are used on kilns that have either 208 or 240 volt power.
