July 2, 2024

Plug-n-Fire Video Support

Plug-n-Fire Video Support

Changing an Element Holder (Video)
qr code

See https://www.youtube.com/video/lkeTR-RWD7Y?ecver=2

This video shows how to change an element holder in an L&L kiln. There are two methods shown.

Question: If the element holder is replaced by chipping off the lower "lip" will the holder remain in place? It seems that unless some type of cement is used it will just work its way out and fall into the kiln. Would you please elaborate?

Answer: What is left after you follow this procedure is a serrated edge. That actually does an excellent job of holding in the groove. This works in almost all cases - you can always cement it if it doesn't work. One of the great things about these holders is that, when you are done, you have a functional groove - stronger than the underlying brick itself.

Paper Test to Analyze Which Elements Work
qr code

See https://www.youtube.com/video/1ZbdSO-SqKs

Running a paper test can be a great way to troubleshoot your kiln if you do not have access to a multimeter. With just some scraps of paper and 5 minutes you can determine if you have any elements or relays that need replacing.

Despite it's usefulness, the paper test cannot compare to the information that you can get from a multimeter. It will only point you in the direction of a problem, not pinpoint it.

You can follow along with our instructional video as well:

First let's go through the test itself:

  • Start by folding up small strips of paper. You will need one paper per element in the kiln that you want to test.
  • Turn off the kiln and unplug it (or at least shut it off at the circuit breaker/fused disconnect).
  • Insert the paper scraps in between the coils of each element. It does not matter where along the element.
  • Plug-in and turn on the kiln.
  • Program for Fast Glaze to any cone (or turn manual
    • Changing a Relay in an L&L Automatic Kiln (Video)
    qr code

    See https://www.youtube.com/video/dFIhqOI8en8

    How To Change A Relay In An Easy-Fire Kilns
  • Be sure to keep the wires on in the right sequence when changing a power or control relay in an Easy-Fire, Easy-Fire XT, School-Master or eQuad-Pro Kiln.
  • The configuration is similar in a Jupiter panel or as control relay in a DaVinci, Hercules, or Easy-Load panel.
  • Make sure kiln is unplugged or locked out and tagged out at the circuit breaker or fused disconnect switch when doing this maintenance.
    • Parts

    See this page for the 12 Volt 30 Amp relay we use for most kilns.

    See this page for the 240 Volt 30 Amp relay we use as a control relay for 480 volt kilns.

    Changing a Fuse Holder on an L&L Automatic Kiln (Video)
    qr code

    See https://www.youtube.com/video/6cfRNR2Tggw?ecver=2

    How to change a control fuse holder in an Easy-Fire Kiln
  • Similar in all L&L kilns with automatic controls.
  • Make sure kiln is unplugged or locked out and tagged out at the circuit breaker or fused disconnect switch when doing this maintenance.
    • Parts
  • See this page for parts.
  • See this page for all fuses and fuse holders.
    		•