SHOP FOR L&L KILN PARTS

Red Pilot Light - Unit is used for All Manual Kiln Control Panels

240 Volt Infinite Zone Switch - Unit includes a Mounting Nut. This can be used for both 240V and 208V Kilns.

NOTE: Often a switch, when it burns out, exhibits overheating on the switch body at one of the spade electrical connection points. When this occurs, the mating connector on the wire may not give good electrical contact if refused. To reduce the possibility of overheating at this point on the new switch, we recommend replacing the female connector and the wire attached to it. If the switch body looks O.K. then do not replace the female wire connectors.

Troubleshooting An INF Swtich

NOTE CONCERNING 208V SWITCHES

When used on a 208 volt kiln the timing of th heater will be slightly different than when used on a 240 volt kiln. We no longer supply 208 volt switches.