Rolling Stand Instructions

Overview

1. The redesigned L&L Rolling Stand comes as a kit that can bolt onto the regular stand of L&L polygonal kilns.
2. If your stand has 4 bolt holes in each corner, and the corners extend outside the exterior of the kiln, then your stand is likely compatible with the new rolling stand kit. 

Parts

• Bolts: (16) ¼” flange-hex-head bolts
• Nuts: (16) ¼” flange-hex nuts
• Leg Assemblies: (4) leg-caster assemblies

Assembly

1. Align legs with corner holes.
2. Insert 4 bolts per leg, with nuts on the inside.
3. Tighten bolts using a wrench.
4. Before placing the kiln on top, lock casters by pressing the levers on the wheels.

Caution

1. Do not remove casters; stand top must be at least 8” from the ground.
2. Rolling Stand is not for moving while kiln is loaded.
3. Avoid rolling on inclines or rough ground.