From Jessica Putnam-Philips from Clayshare:

Learn how and why it is so important to set the bottom kiln shelf correctly. With this simple tip you will prolong the life of your kiln, get better more even firings and better glaze results no matter what size your kiln is.

This video goes shows you various tips and tricks for adjusting and monitoring your kiln while firing with a DynaTrol control.

This video shows you how to use witness cones to check the accuracy of the control and your kiln in an L&L Easy-Fire kiln. This video applies to any kiln.

This video goes into the principles of how to load an electric kiln. In this case it is an L&L Easy-fire e23T kiln.

 This video shows you the basics of how to do routine maintainence on your L&L kiln.

• How to Recall a Vary-Fire Program
• How to Manually Control When Your Vary Fire Program Stops Firing but Still Maintains a Controlled Cooldown
• Standard Easy-Fire Program Profiles in the DynaTrol
• How do I enter a really slow program?
• How do I

How do I control the cooling with the DynaTrol?

This video shows how to replace a DynaTrol on an Easy-Fire kiln. The same principles apply to any kiln with a DynaTrol or Genesis control.

WARNING IF YOU HAVE A TYPE S THERMOCOUPLE: WHEN REPLACING A DYNATROL: CHECK THE CONFIGURATION OF THIS REPLACEMENT CONTROL TO MAKE SURE YOU DON’T MELT YOUR KILN! See this for more information.

How to change a DynaTrol from a three or two-zone control to a single zone or to change to two-zones from three-zones.

See this link on how to change the number of sections on a Jupiter kiln. When you do this you have to change the number of thermocouples on the control.

How to change the thermocouple offset on a DynaTrol. This helps you calibrate the control to match your kiln.

How to fix buttons that are not working on an L&L DynaTrol kiln control.

How to change from Degrees F to C on a DynaTrol control.

How to turn off the error codes on a DynaTrol.

For more detail see this.

How to enter a cone offset into a DynaTrol.

How to adjust the amount of power going to a powered bottom using the settings in the DynaTrol.

This shows you how to create a really long program with up to 16 segment of control on your DynaTrol program control.

How to change cycle time for the contactors/relays on a DynaTrol. We typically recommend 25 second cycle time for most kilns firing ceramics that have mechanical relays or contactors.

How to troubleshoot a DynaTrol (or Genesis or On-touch control) that has no display. 

How to review the program you are firing or are about to fire.

How to change options on the L&L DynaTrol program control.

The first step in firing the kiln is learning the basics of turning on the control and starting to use it.

How to set specialized OTHER options on an L&L DynaTrol program control on L&L kilns.

In this video, we will explain our recommended program for your kiln's first firing using an L&L kiln Dynatrol.

This is our new recommended program and supersedes our old program, which may still be present in your manual.

This video shows you how to recall and use a Vary-fire custom program you have created on the DynaTrol program control on an L&L automatic kiln.