A NEMA1 Panel with Solid State Relays:
A NEMA1 Panel on an EL2424:
480 Volts
For DaVinci and Jupiter JD2900 Kilns
-
Standard DaVinci and JD2900 kilns have three elements per section. Elements are wired in a Star (Wye) Configuration to get 277 volts at the elements. This means the voltage potential in the kiln is much safer than it would be if the elements were running at 480 volts.
-
On Quad versions, we use two 240-volt elements in series.
-
The power supply does not require a neutral (it is a "floating neutral).
-
The watts are the same as 240-volt kilns but the amperage goes down.
-
The required NEMA 1 control panel is a special heavy-duty industrial control panel. These panels are floor-standing on an included stand. They typically sit on the right side of the kiln.
-
The price of the NEMA 1 panel is added to the price of the basic 480-volt option.
-
Each kiln section is separately branch fused.
-
A lighted “On/Off” switch is included.
-
Kiln sections are “hard-wired” (meaning that there are no plugs and receptacles) from the sections to the control panel with a flexible “SO” cord (typically 72” long each).
For Easy-Load Front-Loading Kilns
-
Elements are 240-volt elements wired in series. This means the voltage potential in the kiln is much safer than it would be if the elements were running at 480 volts.
-
The power supply does not require a neutral.
-
The watts are the same as 240-volt kilns but the amperage goes down.
-
The required NEMA 1 panel is floor-standing on an included stand. It typically sits on the right side of the kiln.
-
The price of the NEMA 1 panel is added to the price of the basic 480-volt option.
-
Each kiln section is separately branch fused.
-
A lighted “On/Off” switch is included.
