Video Support

In this video we will explain how to switch your L&L kiln Genesis control from a Type K thermocouple to a Type S thermocouple.

These three videos show you how to use and program the One-Touch Intuitive Kiln Control. There are three segments - basic operation, basic programming of options and advanced ramp/hold programming.

This video shows you how to test element resistance of the circuits on a Jupiter or DaVinci kiln.  

Also see this page about testing for element resistance. 

See this video for checking elements on Easy-Fire, eQuad-Pro, School-Master and many other kilns.

FOR SAFETY'S SAKE: Be sure to unplug the kiln before performing this test. If you do that there is no chance of any shock even if you are not experienced.

This video tutorial demonstrates how to properly stretch and install replacement quad elements for our eQuad kilns. 

In this video, we demonstrate how to change a single-phase kiln into a three-phase L&L Easy-Fire or School-Master kiln. 

Although this video is specific to these kiln series, the basic principle applies to most 280 and 240-volt kilns. Kilns with higher amperage will not have the cord, but all 208 and 240-volt kilns can do the same easy change at the terminal block. 

In this video we will demonstrate how to bend quad elements for our square and rectangular kilns

The video demonstrates how to perform a simple paper test to diagnose issues with a kiln. This quick method helps determine if elements or relays need replacing by observing which paper strips burn when inserted into the kiln's elements during a test firing (0:16, 0:38). If a single element's paper doesn't burn, it suggests a wiring issue or a broken element (2:06). If paper in an entire ring doesn't burn, it could indicate multiple burnt-out elements, a faulty relay, or a controller issue (2:17). The paper test is a starting point for troubleshooting your kiln.

How to stretch and/or compress kiln elements.

In this video we demonstrate how to replace the elements and the thermocouple in a Plug-N-Fire PF8

This video shows you how to test element resistance of the circuits on an Easy-Fire kiln. Most Easy-fire kilns are wired in parallel and the resistance you will get in this test gets multiplied by two to get the element resistance. You can find your proper element resistance by looking at your wiring diagram and looking for the ohms rating of the elements (which changes with voltage and phase). Make sure you know the voltage and phase of your kiln when you are checking this. 

This basic method will serve for many of L&L kilns like the eQuad-Pro and School-Master series. See this video for how to check elements on a Jupiter or DaVinci kiln. Instead of opening up the control box as shown on those kilns you just unplug the section cords and measure from the plug ends. Be sure to follow the specific instructions in this page: Also see

How to change the elements in an L&L Chameleon kiln.