How do I control the cooling with the DynaTrol?

This video shows how to replace a DynaTrol on an Easy-Fire kiln. The same principles apply to any kiln with a DynaTrol or Genesis control.

WARNING IF YOU HAVE A TYPE S THERMOCOUPLE: WHEN REPLACING A DYNATROL: CHECK THE CONFIGURATION OF THIS REPLACEMENT CONTROL TO MAKE SURE YOU DON’T MELT YOUR KILN! See this for more information.

How to change a DynaTrol from a three or two-zone control to a single zone or to change to two-zones from three-zones.

See this link on how to change the number of sections on a Jupiter kiln. When you do this you have to change the number of thermocouples on the control.

How to change the thermocouple offset on a DynaTrol. This helps you calibrate the control to match your kiln.

How to change from Degrees F to C on a DynaTrol control.

How to fix buttons that are not working on an L&L DynaTrol kiln control.

How to turn off the error codes on a DynaTrol.

For more detail see this.

How to enter a cone offset into a DynaTrol.

How to adjust the amount of power going to a powered bottom using the settings in the DynaTrol.

This shows you how to create a really long program with up to 16 segment of control on your DynaTrol program control.