Video Support

Quick tip for replacing the hinge on an L&L e18 kiln.

In this video we will walk you through the unpacking and assembly process for an L&L Easy-Fire Kiln!

The assembly process will be similar for most of our polygonal kilns, such as our school master and equad-pro kilns, but if you have any questions about your specific model you can reach out to service@hotkilns.com

PDF Assembly Instructions

Shipping, receiving, and inspecting kilns page

Assembling a Vent-Sure Downdraft Vent

First Firing on an L&L Kiln Genesis Control

This video demonstrates the proper unpacking procedure for the L&L Easy-Load Kiln, ensuring a safe and efficient setup from the moment your kiln arrives.

Your kiln arrives in a heavy-duty wooden crate. Begin by removing the plywood top and side panels, then fully dismantle the wooden frame. Once exposed, remove the plastic wrap surrounding the kiln.

Unbolt the kiln from the shipping pallet. With the bolts removed, position a forklift under the kiln—making sure the forks are centered, straight, and placed on either side of the bypass collection box.
Lift the kiln slowly and slide the pallet out from underneath. Lower the kiln gently into its installation area.

• A forklift is required for lifting the kiln from the pallet.
• After it is on the ground, you may move it using a pallet jack under the metal frame.

This video show you how to adjust a door to seal properly on an L&L eFL Series front-loading kiln 
 

From Jessica Putnam-Philips:

Yes, you can install a kiln vent. If I can do it you can do it! In this video, I walk you through all the steps to safely install the kiln vent.

This video shows how to drill your kiln bottom for a Vent-Sure ventilation system in case you are installing on a new kiln or if your holes are not already predrilled. The number and sizes of holes can be determined by looking in the vent instructions.

The Vent Control allows you to automatically control the operation of the Vent-Sure kiln vent with one of the outputs from the DynaTrol (or Genesis).

Also see this link.

Installation instructions for L&L's Vent-Sure Downdraft Kiln Vent.

See this page.

See this page.

Installation instructions for L&L's new reengineered spring hinge system.

How to retrofit your kiln with L&L's new hinge technology.

This video shows you how to adjust the spring tension on your spring hinge in case the lid is too heavy or too light.