KNOWLEDGEBASE

KNOWLEDGEBASE

How do I program a slump or tack or full fuse glass program into DynaTrol?

This program is fine for slumping, tack fusing, or full fusing, just substitute different top temperatures when programming. The step in the programming marked with a "*" at the end of it is the one to change.

For slumping use 1220 (Fahrenheit)

For tack fusing use 1350

For full fusing use 1480

You may have to adjust these temps a little higher or lower depending on your tests.

Additionally the 10 minute hold time at the highest temp may need to be adjusted longer or shorter as well. This hold time is the number entered in the next step after the step with the "*" on it.

To enter this program do the following:

  1. Set the toggle switch for the kiln to ON
  2. Press ENTER, Or if it says to WAIT, do it, then look for "IDLE" to appear along with TC # and the temp inside.
  3. Press the following keys:
  4. ENTER PROG
  5. 1
  6. ENTER
  7. 8
  8. ENTER
  9. 500
  10. ENTER
  11. 250
  12. ENTER
  13. 12
  14. ENTER
  15. 500
  16. ENTER
  17. 500
  18. ENTER
  19. 12
  20. ENTER
  21. 500
  22. ENTER
  23. 750
  24. ENTER
  25. 12
  26. ENTER
  27. 600
  28. ENTER
  29. 1250
  30. ENTER
  31. 20
  32. ENTER
  33. 600
  34. ENTER
  35. 1350*
  36. ENTER
  37. 10
  38. ENTER
  39. 9999
  40. ENTER
  41. 1000
  42. ENTER
  43. 100
  44. ENTER
  45. 90
  46. ENTER
  47. 970
  48. ENTER
  49. 100
  50. ENTER
  51. 120
  52. ENTER
  53. 750
  54. ENTER
  55. 1
  56. ENTER
  57. 9999
  58. ENTER
  59. START

In the future when you want to run this program, you can call it up from the memory and run it by pressing RECALL PROG/ 1/ ENTER/ START.