KNOWLEDGEBASE
KNOWLEDGEBASE
An electric kiln atmosphere rich in oxygen will make elements, kiln-sitters, and thermocouples
The pliers to get for grabbing the wire and bending it around the bolt are called Linesman Pliers
All of the DynaTrol or Genesis controlled L&L Kilns
When you are installing the circuit for your new kiln, it is important to use the correct type
Keep in mind that you run the risk of over-firing if you restart while the kiln is very close to
TC1 is the top and TC2 is the bottom.
Three Zone Kiln (withWe double-twist element ends that are 14 gauge and thinner. We do not twist element ends on 13
When this happens, it almost always means the hinge is out of adjustment or set too low on the
When this happens, it almost always means the hinge is out of adjustment or set too low at the
Corrosion on a kiln is perfectly normal... mostly because it is a kiln! Hot-to-cold-to-hot
The work is overfired but there is no error code. Here are some things to look for:
If your kiln underfires with no error code:
- On 3-section kilns with wires running to N, L1, L2, and L3 all 3 amp readings (L1,