Choose by Kiln Filter
Choose by Kiln Model
Mini-Catalog / Price List
Full Specification Catalog
Vent-Sure Kiln Vent
KISS Computer & Remote Control
Choosing a School Kiln
Surplus Kilns & Parts
Checking & Fixing
Error Codes (DynaTrol)
Calibrating Your Kiln
BTU Analysis for HVAC
Electricity for Kilns
Discontinued Kiln Series
Get Technical Support
Join our email list
Pages that link to DynaTrol Control Instructions (Blue Face 5.0 Current from 1/06)
DynaTrol Control Instructions (Blue Face 5.0 Current from 1/06)
What links here
What to do if there is no display on the DynaTrol
How to Ensure that Kiln Has Been Programmed Correctly
How to fix E-1 or Err1
Automatic Zone Control
What is an Automatic Control Box?
How to interpret a garbled message on the DynaTrol
Display Reads 2400 or CPLt When it Starts Up
Does the Bartlett overtemperature control have a reset button like a "normal" overtemperature control?
How to fix E- 2 or Err2
How to fix E-22 or E- 6 error code on the DynaTrol
How to fix E-d or Errd
Kiln DynaTrol Control Error Codes
Why does the temperature read-out on my hand-held pyrometer differ from the temperature shown on the DynaTrol?
Some of the buttons on the DynaTrol do not work. How do I fix this?
How do hold times and heatwork affect my work?
Why does my kiln stall or stop heating with lots of clicking (relays) and no error code?
Why does my kiln seem like it overfires the pottery?
Why does my kiln jump over the Preheat without holding at the Preheat temp?
Can I Restart the Kiln after Getting an Error Message?
How do I program a slump or tack or full fuse glass program into DynaTrol?
Does the digital controller have a way to prevent an over fire?
How high can the DynaTrol be programmed to fire to?
The center of my kiln gets too hot compared to the top and bottom.
What to do if the kiln fires slowly?
What's the Worst thing that can Happen from Restarting After an Error Code?
What to do when you see "FAIL"?
What is the E- A code on the DynaTrol and how do you fix it?
How do I enter a really slow program?
E-4, E- 4, or Err4 error code: What it means, when you might see it, and what to do about it.
Thermocouple Offset Setting and Cone Offset Setting
L&L Kiln Mfg Inc
505 Sharptown Road
Swedesboro, NJ 08085
Toll Free: 800-750-8350
Terms & Conditions of Sale
Email This Page
Join our Email list
©2015 L&L Kiln Mfg Inc
(c) 2015 L&L Kiln Mfg Inc. All Rights Reserved.
505 Sharptown Road | Swedesboro, NJ 08085 | 800-750-8350