One of the most difficult kiln performance problems to address is a problem with the electrical supply to the kiln.
How to change cycle time for the contactors/relays on a DynaTrol. We typically recommend 25 second cycle time for most kilns firing ceramics that have mechanical relays or contactors.
How to enter a cone offset into a DynaTrol.
How to turn off the error codes on a DynaTrol.
For more detail see this.
How to change from Degrees F to C on a DynaTrol control.
How to change the thermocouple offset on a DynaTrol. This helps you calibrate the control to match your kiln.
How to change a DynaTrol from a three or two zone control to a single zone.
TC1 is the top and TC2 is the bottom.
TC1 is the top, TC2 is the middle and TC3 is the bottom.