How to check to see if the internal switches on a DynaTrol board are operating properly.
This video shows how to change the on/off switch on an L&L automatic kiln.
Available only during a hold period. This option allows you to add time in 5 minute increments to a hold (soak) period.
Change of Program During Firing: When firing you can alter the program anytime. You must press START/STOP, then reprogram, then press “Start”.
A customer asks: I would like to program my kiln to heat to Cone 6 then cool normally to 950°F and then hold for one hour at 950°F and then cool naturally.
The ultimate in precision firing is achieved by using the DynaTrol to control the ramping of the kiln (both up and down) but using a witness cone and your eye to control when the firing stops.
How to check the operation of a control transfomer on an L&L automatic kiln. Applies to all automatic kilns that are not 480 volts.